What is a speed of cache accessing for modern CPUs? How many bytes can be read or written from memory every processor clock tick by Intel P4, Core2, Corei7, AMD?
Please, answer with both theoretical (width of ld/sd unit with its throughput in uOPs/tick) and practical numbers (even memcpy speed tests, or STREAM benchmark), if any.
PS it is question, related to maximal rate of load/store instructions in assembler. There can be theoretical rate of loading (all Instructions Per Tick are widest loads), but processor can give only part of such, a practical limit of loading.
For nehalem: rolfed.com/nehalem/nehalemPaper.pdf
Each core in the architecture has a 128-bit write port and a
128-bit read port to the L1 cache.
128 bit = 16 bytes / clock read AND 128 bit = 16 bytes / clock write (can I combine read and write in single cycle?)
The L2 and L3 caches each have a 256-bit port for reading or writing,
but the L3 cache must share its port with three other cores on the chip.
Can L2 and L3 read and write ports be used in single clock?
Each integrated memory controller has a theoretical bandwidth
peak of 32 Gbps.
Latency (clock ticks), some measured by CPU-Z's latencytool or by lmbench's lat_mem_rd - both uses long linked list walk to correctly measure modern out-of-order cores like Intel Core i7
L1 L2 L3, cycles; mem link
Core 2 3 15 -- 66 ns http://www.anandtech.com/show/2542/5
Core i7-xxx 4 11 39 40c+67ns http://www.anandtech.com/show/2542/5
Itanium 1 5-6 12-17 130-1000 (cycles)
Itanium2 2 6-10 20 35c+160ns http://www.7-cpu.com/cpu/Itanium2.html
AMD K8 12 40-70c +64ns http://www.anandtech.com/show/2139/3
Intel P4 2 19 43 200-210 (cycles) http://www.arsc.edu/files/arsc/phys693_lectures/Performance_I_Arch.pdf
AthlonXP 3k 3 20 180 (cycles) --//--
AthlonFX-51 3 13 125 (cycles) --//--
POWER4 4 12-20 ?? hundreds cycles --//--
Haswell 4 11-12 36 36c+57ns http://www.realworldtech.com/haswell-cpu/5/
And good source on latency data is 7cpu web-site, e.g. for Haswell: http://www.7-cpu.com/cpu/Haswell.html
More about lat_mem_rd program is in its man page or here on SO.
Widest read/writes are 128 bit (16 byte) SSE load/store. L1/L2/L3 caches have different bandwidths and latencies and these are of course CPU-specific. Typical L1 latency is 2 - 4 clocks on modern CPUs but you can usually issue 1 or 2 load instructions per clock.
I suspect there's a more specific question lurking here somewhere - what is it that you are actually trying to achieve ? Do you just want to write the fastest possible memcpy ?
来源：https://stackoverflow.com/questions/2353299/cache-bandwidth-per-tick-for-modern-cpus