问题
I've seen the page on amazon and understand that 1 RCU is a 4KB item.
If I have a table with 50 items, I've read that a scan will read the full 50 items and use 50 RCU. But lets say I did a query, my table is 10 by 5, will it still use 50 RCU?
回答1:
Scanning a table that contains 50 items will consume 50 RCU only if the total size of the 50 items combined equal 200KB (for a strongly consistent read, or 400KB for an eventual consistent read). Most items are not that big, so a 50 items typically only require about 10KB to store meaning a full scan for a table of 50 items, with eventual consistency, would only cost about 3 RCU.
The consumed Read Capacity Units (RCU) depends on multiple factors:
- the operation (ie. Get vs. Query/Scan)
- the size of the items
- whether the read is strongly consistent or eventually consistent
If an item is read using a GetItem operation than the consumed capacity is billed in increments of 4KB, based on the size of the item (ie. a 200B item and a 3KB item would each consume 1RCU, while a 5KB item would consume 2 RCU)
If you read multiple items using a Query or Scan operation, then the capacity consumed depends on the cumulative size of items being accessed (you get billed even for items filtered out of a query or scan when using filters). So, if your query or scan accesses 10 items, that are approximately 200 bytes each in size, then it will consume only 1 RCU. If you read 10 items but each item is about 5KB in size, then the total consumed capacity will be 13 RCU (50KB / 4KB = 12.5, rounded up, is 13)
What's more, if you perform an eventual consistent read, then you can double the size per capacity unit. So it would only cost 7 RCU to read the 10 5KB items.
You can read more about throughput capacity here.
A couple of things to note:
- a single item may be as large as 400KB, so reading an item could consume as much as 100 RCU.
- when calculating item size, attribute names count towards the item size as well, not just their values!
来源：https://stackoverflow.com/questions/50178275/how-are-consumed-read-capacity-units-calculated-in-dynamodb-query