With bash, how can I pipe standard error into another process?

问题

It's well known how to pipe the standard ouput of a process into another processes standard input:

proc1 | proc2

But what if I want to send the standard error of proc1 to proc2 and leave the standard output going to its current location? You would think bash would have a command along the lines of:

proc1 2| proc2

But, alas, no. Is there any way to do this?

回答1:

There is also process substitution. Which makes a process substitute for a file.
You can send stderr to a file as follows:

process1 2> file

But you can substitute a process for the file as follows:

process1 2> >(process2)

Here is a concrete example that sends stderr to both the screen and appends to a logfile

sh myscript 2> >(tee -a errlog)

回答2:

You can use the following trick to swap stdout and stderr. Then you just use the regular pipe functionality.

( proc1 3>&1 1>&2- 2>&3- ) | proc2

Provided stdout and stderr both pointed to the same place at the start, this will give you what you need.

What the x>y bit does is to change file handle x so it now sends its information to where file handle y currently points. For our specific case:

3>&1 creates a new handle 3 which will output to the current handle 1 (original stdout), just to save it somewhere for the final bullet point below.
1>&2 modifies handle 1 (stdout) to output to the current handle 2 (original stderr).
2>&3- modifies handle 2 (stderr) to output to the current handle 3 (original stdout) then closes handle 3 (via the - at the end).

It's effectively the swap command you see in sorting algorithms:

temp   = value1;
value1 = value2;
value2 = temp;

回答3:

Bash 4 has this feature:

If `|&' is used, the standard error of command1 is connected to command2's standard input through the pipe; it is shorthand for 2>&1 |. This implicit redirection of the standard error is performed after any redirections specified by the command.

zsh also has this feature.

With other/older shells, just enter this explicitly as

FirstCommand 2>&1 | OtherCommand

回答4:

Swapping is great as it solves the problem. Just in case you do not even need the original stdout, you can do it this way:

proc1 2>&1 1>/dev/null | proc2

The order is vital; you would not want:

proc1 >/dev/null 2>&1 | proc1

As this will redirect everything to /dev/null!

回答5:

None of these really worked very well. The best way I found do do what you wanted is:

(command < input > output) 2>&1 | less

This only works for cases where command does not need keyboard input. eg:

(gzip -d < file.gz > file) 2>&1 | less

would put gzip errors into less

来源：https://stackoverflow.com/questions/1507816/with-bash-how-can-i-pipe-standard-error-into-another-process

标签

bash

pipe

stderr