问题
I recently set up a CentOS 6.4 basic LAMP server (no GUI) in a pre-built Virtualbox image, and then followed the installation guide/steps for MarkLogic.
When I attempt install with rpm -i /tmp/MarkLogic-8.0-1.x86_64.rpm, MarkLogic states that it cannot find libc.so.6, however when I run the command whereis libc.so.6, the shell responds with /lib64/libc.so.6
I would make a symbolic link I suppose, but I'm not sure where MarkLogic is expecting that file to be.
Does anyone have experience installing MarkLogic on Centos6 and how to verify the install is working properly? While ML gave some good instructions, I am very new to CentOS and Redhat, in general.
回答1:
Running the following yum command before installing MarkLogic should be sufficient normally:
yum -y install glibc.i686 gdb.x86_64 redhat-lsb.x86_64
You can also look at this and related scripts for more inspiration:
https://github.com/grtjn/mlvagrant/blob/master/opt/mlvagrant/install-ml-centos.sh#L17
HTH!
来源：https://stackoverflow.com/questions/28703042/install-marklogic-centos-virtualbox-vm