What data is included in ICMP (ping) request?

半腔热情 提交于 2020-05-14 16:07:14

问题


I know the ICMP request contains the IP address. Is the client MAC address included in an ICMP request? What other info (if any) is included in a ping request?


回答1:


An ICMP request is a layered packet which is sent over the internet. It contains the Ether layer, which has the target and source MAC address in it. It also contains the IP layer, which has the source and target IP and also a couple of flags included. And at last it contains the ICMP data. This contains a type, a subtype, then a checksum and the rest of the header, which can vary from type and subtype (E.g. The code for echo is 8 and reply is 0).

There is a lot of information in a network packet. Also note that ICMP is an part of the IPv4 protocol, so it cannot officially be carried by other protocols. Although the IP protocol can be carried on a different protocol than the ethernet protocol.

The MAC address will be changed after each passing of a router. So this is never the MAC address of the source IP address on the internet. But the IP address is definitely included and on a local network, the mac address of the client is still in the packet in the Ether layer.

Wikipedia has some readable article about ICMP packets: icmp message and different protocols with readable diagrams.

If you want to see some live requests, you can install wireshark, which will show and dissect all network traffic for you. It is a very convenient and cool tool.




回答2:


The ICMP 'ping' packet, officially known as 'echo request', contains whatever the originating ping executable wants to have echoed back to it. In the Bad Old Days when the internet was first getting started up, the routers they had (and all computers, really) were subject to random memory failures. In order to detect that the path between two systems was clear, they would send echo request packets and compare the contents of the request with the reply. If the contents differed, they knew that there was a problem with either of the machines involved, or the routers in between.

It's impossible to state here categorically exactly what's in any given ping packet because it changes between implementations of ping.




回答3:


It is usually not possible for a person to get the MAC address of a computer from its IP address alone. These two addresses originate from different sources. Simply stated, a computer's own hardware configuration determines its MAC address while the configuration of the network it is connected to determines its IP address. However, computers connected to the same TCP/IP local network can determine each other's MAC addresses.

Look RFC 792 for full ICMP fields.



来源:https://stackoverflow.com/questions/19552134/what-data-is-included-in-icmp-ping-request

标签
易学教程内所有资源均来自网络或用户发布的内容,如有违反法律规定的内容欢迎反馈
该文章没有解决你所遇到的问题?点击提问,说说你的问题,让更多的人一起探讨吧!