I am trying to force a 9-bit protocol on a UART in embedded Linux. Currently I am testing this out on the am335x_evm board. I am planning on doing this using stick parity. Ideally I was hoping I would not need to actually modify any of the code for the omap-serial.c driver.
The reason for the 9-bit protocol is to support some legacy hardware that uses it. The parity bit needs to be 1 for the address portion of the message, 0 for the data portion, then 1 again for the termination byte.
I was planning on having a process running in user space that would interface with the UART through standard system calls (open, write, read, ioctl, tcsetattr, etc). I would configure the UART to enable parity and set the stick parity. I would then set the parity to even and call write() to send out my address data. I would then set the parity to 0 and send out the data. My concern is if I change the parity from 1 to 0, when does that take affect? If the UART is not done sending all the address data, will the change in parity apply to any unsent data?
Ended up writing my own 9-bit uart driver. Was the easiest and most efficient solution.
Proper way is to set cs9 on your serial port (and possibly no parity), provided that hardware and driver support this.
I'll search for a link for you...
来源：https://stackoverflow.com/questions/26887468/9-bit-protocol-on-uart-in-embedded-linux