“refusing to merge unrelated histories” failure while pulling to recovered repository

Question

I come up with a problem about Git push.

It worked successfully before, but it failed this time. In the beginning, I am in my master MINGW64 /d/javasoft/apache

Answer 1

This cannot be answered shortly.

Warning: You should not use the --allow-unrelated-histories flag unless you know what unrelated history is and are sure you need it. The check was introduced just to prevent disasters when people merge unrelated projects by mistake.

As far as I understand, in your case has happened the following:

You have cloned a project at some point 1, and made some development to point 2. Meanwhile, project has evolved to some point 3.

Then you for some reason lost your local .git subdirectory - which contained all your history from 1 to 2. You managed to restore the current state though.

But now it does not have any history - it looks like the whole project has appeared out of nowhere. If you ask Git to merge them it will not be able to say where your changes are, so it can add them to remote project, as far as I understand it will just report massive add/add conflicts.

You should now find back that commit 1 from the remote history where you have cloned the project (I assume you did not pull after that; if you did then you should instead look for the last commit you have pulled). Then you should modify your history so that is starts from that commit 1, and then Git will be able to merge correctly (with pull for example).

So, the steps (assuming you are now in your restored commit without history):

• estimate where is the commit 1 you have cloned from as some 1?, based on commit time for example
• run git diff _1?_..HEAD, and read carefully. Make sure that the difference contains only edits which you have made. If it contains more then you should have picked a bit wrong 1? and need to adjust it and repeat this step
• after you have found the commit 1. You should make it your parent; do git --reset --soft _1_, and then git commit.

Now it looks like you have cloned from 1, then made one commit with all your changes. Your intermediate history is lost anyway with your older .git directory, but now you can run your git pull - it will merge correctly.

Answer 2

Try to commit the changes to the local repository efore pushing them onto GitHub.

It may solve the issue (I had a similar issue).