Tell when Bluetooth module connects on Arduino

Question

I\'m working on a project with Android and Arduino and am trying to figure out how on the Arduino side to tell if the Bluetooth is connected or not.

I\'m using one of

Answer 1

Using the module supplied and nothing else you cannot: notice the module has four connectors:

• Power (Vcc)
• Ground
• Tx (send)
• Rx (receive)

Given this interface the only way to determine whether the bluetooth module is paired is to send something to the paired device and have it respond in such as way that your Arduino knows that it is connected. For instance, if your Android program always responds with "Hi there!" when it receives a string "Hello?", then by seingin "Hello?" your Arduino will know that it is paired with your Android phone/tablet. Your Arduino could poll (send the interrogation string) every minute (or every five seconds) to see if it is paired with your device.

---

There is a better way, but it will require some soldering on your part. If your module is HC-03/HC-05-based, then the PIO9 pin is the "paired indicator LED" (see datasheet here). You could connect that pin to an Arduino input pin and read the level: reading digital 1 will indicate that the device is paired, while reading digital 0 will indicate that it is not. It is possible, though not certain, that the pin on your module labeled STATE is exactly this kind of a pin, i.e. it indicates the paired status. Unfortunately. this pin it isn't connected to the header, so you'll have to solder a wire to the correctponding pad to connect it to your Arduino. You should test it first by connecting a multimeter in voltage mode to that pad and measure the potential between that pad and ground in paired and non-paired state. If this is the pin that responds to the paired state then you are golden. It might be that it indicates power (like the HC-03/05 PIO8 whilc blinks when on). If it turns out that the STATE pin is not the pairing status, then you should request a datasheet from your supplier, and use that to find the status LED connection: one is likely to exist. Once you found the correct pad, verify its function using the voltmeter again. Then solder a wire to that connection and read it from your Arduino.

IMPORTANT: Make sure that your Arduino never puts out a digital 1 on the Arduino pin connected to the bluetooth module status pin: these bluetooth modules run on 3.3V, and connecting any unprotected pins to 5V will be damaging. The Vcc and Txd pins are voltage shifted in the module you bought, but the LED/Status lines are likely not to be. So if the Arduino pin connected to "status" on your Bluetooth module is configured as output and you digitalWrite(HIGH) to it, you will likely damage the Bluetooth module.