How to set $(OutDir), $(TargetName), $(TargetExt), and %(Lib.OutputFile) with Visual Studio?

Question

I\'m trying to build gtest on Visual Studio 2010. After converting the solution file, I tried to build, and I got the following warning messages.

Warning 1           


        

Answer 1

This kind of errors typically arise when upgrading old project to new version of Visual Studio (like in your case to VS2010) and also if project settings may have been manually changed (for example changing executable name). We know VS2010 uses these macros $(ProjectName) $(TargetName) $(OutDir) $(TargetExt) to control release/debug outputs but it is often mystery where to change them. We than typical resort to changing the name of output files directly through Project >> Properties. This means we now have to change the output files separately for debug and release build and if there was any dependencies, we will get error like This may cause your project to build incorrectly..

These macros/properties are VS2010 defaults but you can set them yourself in .vcproj files by editing it in notepad. Note search first for the property in the .vcproj file first, if its there than change its value, if not define it like below.

  
    New_Project_Name
  

Above I have defined a new to keep these values but you can define them anywhere. I define this at the top of the file right after debug/release configuration group so its visible everywhere. Make sure your project properties are setup properly to use them correctly (they should be what is VS2010 default settings). If you have changed them you should copy it from new test project. You can of course add the other Macros you want to set values for in the above group as well.

You can also verify the new values of this macros through project properties. For example click in Configuration Properties >> General and than in 'Target Name' box. Select edit. It will bring up a dialog box with the button 'MACROS >>'. Click that and it will show you what the value of each macro is. It should correctly reflect the new values that you set in .vcproj file.