Are disk sector writes atomic?

Question

Clarified Question:

When the OS sends the command to write a sector to disk is it atomic? i.e. Write of new data succeeds fully or old data is left intact should the

Answer 1

The answer to your first question depends on the hardware involved. At least with some older hardware, the answer was yes -- a power failure could result it garbage being written to the disk. Most current disks, however, have a bit of a "UPS" built into the disk itself -- a capacitor that's large enough to power the disk long enough to write the data in the on-disk cache out to the disk platter. They also have circuitry to detect whether the power supply is still good, so when the power gets flaky, they write the data in the cache to the platter, and ignore garbage they might receive.

As far as a "torn page" goes, a typical disk only accepts commands to write an entire sector at a time, so what you'll get will normally be an integral number of sectors written correctly, and others remaining unchanged. If, however, you're using a logical page size that's larger than a single sector, you can certainly end up with a page that's partially written.

That, however, mostly applies to a direct connection to a normal moving-platter type hard drive. With almost anything else, the rules can and often will be different. Just for an obvious example, if you're writing over the network, you're mostly at the mercy of the network protocol in use. If you transmit data over TCP, data that doesn't match up with the CRC will be rejected, but the same data transmitted over UDP, with the same corruption, might be accepted.