How to add timestamp to STDERR redirection

Question

In bash/ksh can we add timestamp to STDERR redirection?

E.g. myscript.sh 2> error.log

I want to get a timestamp written on the log too.

Answer 1

If you're talking about an up-to-date timestamp on each line, that's something you'd probably want to do in your actual script (but see below for a nifty solution if you have no power to change it). If you just want a marker date on its own line before your script starts writing, I'd use:

( date 1>&2 ; myscript.sh ) 2>error.log

What you need is a trick to pipe stderr through another program that can add timestamps to each line. You could do this with a C program but there's a far more devious way using just bash.

First, create a script which will add the timestamp to each line (called predate.sh):

#!/bin/bash
while read line ; do
    echo "$(date): ${line}"
done

For example:

( echo a ; sleep 5 ; echo b ; sleep 2 ; echo c ) | ./predate.sh

produces:

Fri Oct  2 12:31:39 WAST 2009: a
Fri Oct  2 12:31:44 WAST 2009: b
Fri Oct  2 12:31:46 WAST 2009: c

Then you need another trick that can swap stdout and stderr, this little monstrosity here:

( myscript.sh 3>&1 1>&2- 2>&3- )

Then it's simple to combine the two tricks by timestamping stdout and redirecting it to your file:

( myscript.sh 3>&1 1>&2- 2>&3- ) | ./predate.sh >error.log

The following transcript shows this in action:

pax> cat predate.sh
    #!/bin/bash
    while read line ; do
        echo "$(date): ${line}"
    done
pax> cat tstdate.sh
    #!/bin/bash
    echo a to stderr then wait five seconds 1>&2
    sleep 5
    echo b to stderr then wait two seconds 1>&2
    sleep 2
    echo c to stderr 1>&2
    echo d to stdout
pax> ( ( ./tstdate.sh ) 3>&1 1>&2- 2>&3- ) | ./predate.sh >error.log
    d to stdout
pax> cat error.log
    Fri Oct  2 12:49:40 WAST 2009: a to stderr then wait five seconds
    Fri Oct  2 12:49:45 WAST 2009: b to stderr then wait two seconds
    Fri Oct  2 12:49:47 WAST 2009: c to stderr

As already mentioned, predate.sh will prefix each line with a timestamp and the tstdate.sh is simply a test program to write to stdout and stderr with specific time gaps.

When you run the command, you actually get "d to stdout" written to stderr (but that's your TTY device or whatever else stdout may have been when you started). The timestamped stderr lines are written to your desired file.