Haproxy + netty: Way to prevent exceptions on connection reset?

Question

We\'re using haproxy in front of a netty-3.6-run backend. We are handling a huge number of connections, some of which can be longstanding.

Now the problem is that when h

Answer 1

Note : As per my understanding, You don't have to worry about Connection Reset Exception's, unless you've a Connection Pooling at your end with Keep-Alive Connections.

I faced a similar issue with lots of Connection Reset (RST) (It used to be 5-20times in a window of 10seconds, based on load) while using HAProxy for our services.
This is how I fixed it.

We had a system where connections are always kept-alive (keep-alive is always true at HTTP connection level. i.e., Once a connection is established, we reuse this connection from HTTP Connection pool for subsequent calls instead of creating new ones.)

Now, As per my debugging in Code and TCP Dump I found RST's were thrown from HAProxy in below scenario's

1. When HAProxy's timeout client or timeout server had reached, on an Idle Connection.
   This configuration was set as 60seconds for us. Since we have a pool of connections, when the load on server decreases it would result in some of these connections not getting used for a minute.
   So these connection's were then closed by HAProxy using a RST Signal.

2. When HAProxy's option prefer-last-server was not set.
   As per the Docs:

The real use is for keep-alive connections sent to servers. When this option is used, haproxy will try to reuse the same connection that is attached to the server instead of rebalancing to another server, causing a close of the connection.

Since this was not set, everytime a connection was re-used from the pool, HAProxy used to Close this connection using RST Signal and create a new one to a different server (As our Load Balancer was set to round-robin). This was messing up and rendering the entire Connection Pooling useless.

So the Configuration that worked Fine:

1. option prefer-last-server : So existing Connections to a server will be re-used.
   Note: This will NOT cause the Load balancer to use previous server over new server for a new connection. The decision making for new connections is always based on the load balancing algorithm. This option is only for an existing connection which was already alive between a client and a server.
   When I tested with this option, new connection was still going to a server2 even though the connection before this was sent to server1.
2. balance leastconn : With Round robin and Keep-Alive, there could be skewing of connections to a single server. (Say there are just 2 servers and when One server goes down due to deployment, then all new connections will start going to the other server. So even when server2 comes up, round-robin would still allocate new requests one to server1 and one to server2 alternatively. In spite of server1 having a lot of connections at its end. So the Server's load is never exactly Balanced.).
3. Setting HAProxy's timeout client or timeout server to 10minutes. This increased amount of time our connections could stay idle.
4. Implemented an IdleConnectionMonitor : With the timeout being set to 10m, the chances of RST from HAProxy was reduced but not eliminated.
   To remove it completely, we added a IdleConnectionMonitor which was responsible for closing connections which was idle for more than 9Minutes.

With these configurations, we could

• Eliminate the Connection Reset
• Get Connection Pooling working
• Ensured the load balancing happens evenly across Servers no matter what time they start.

Hope this helps!!