问题
What's the difference between or eax,eax and test eax,eax? I've seen different compilers produce both for the same comparison and as far as documentation goes they do exactly the same thing, so I'm wondering why they don't all use test eax,eax. Thinking about it and eax,eax would set the flags in an identical fashion as either but I haven't seen it in either freepascal, delphi, or msVC++.
I did compile some asm blocks in delphi and checked out the assembler source and all 3 forms are the exact same length in opcodes and also checked the intel performance PDF and it says they have the same latency and throughput.
Edit:
The question is specifically about the difference between the specific cases test eax,eax, or eax,eax and and eax,eax. All 3 give completely identical results for registers, flags, opcode length, latency, throughput. And yet for testing if 0, if not zero, or if signed, some compilers will use test eax,eax while some use or eax,eax, and I was wondering why they aren't all using test eax,eax since it makes the code very slightly clearer.
Edit2:
For reference I'm at home and only have and older msvc++ and Delphi here, but testing a variable if zero, msvc++ does test eax,eax, while Delphi does or eax,eax.
回答1:
In general, the only difference between test and and is that test <reg>, <reg> doesn't modify its operands. Essentially test applies an and operation, discarding the non-flags part of the result. If the operands are identical, the results will be the same (as will or).
test can be a superior instruction choice because of things like micro-op fusion. As a result, test is usually preferred unless the computation would have to be repeated. The same thing goes for cmp/sub.
Search Intel's doc for "fusion" and you should find the details.
回答2:
Just to reiterate a little of, and add a little to, what @gsg indicated, the TEST instruction does a bitwise logical comparison (essentially ANDing them bitwise internally but not storing the result) of two operands and sets the processor flags according to the result of that operation. The OR instruction does a logical OR of the source with the destination, storing the result in the destination and sets the processor flags according to the result. They both affect the processor flags the same way. So when the operands are identical, the behavior is the same. There is no difference in flags. However, when the operands are different, their behavior is then quite different. You can also test for zero with and eax,eax which also affects the flags identically.
回答3:
The circuitry to determine that the contents of eax after test eax, eax are the same as before the instruction is simpler than the circuitry required to arrive to that conclusion for or eax, eax. For this reason, test is better.
Some compilers may have generated or at a time when it did not make any difference (before out-of-order execution), but it will make a difference with some out-of-order processors nowadays (whereas yet other OOO processors will be so sophisticated that they will recognize or eax, eax as truly equivalent to test eax, eax).
I couldn't find a reference justifying that some modern processors are actually able to infer that or reg, reg does not modify reg, but here is an answer claiming it is the case for xchg reg, reg.
来源：https://stackoverflow.com/questions/23691989/difference-between-or-eax-eax-and-test-eax-eax