“No such module 'Alamofire'” Xcode won't recognize Alamofire framework

问题

I realize that the same error was asked in other questions (like here), but their solutions are not working for me. I keep getting a build failure in my app: "No such module 'Alamofire'". I followed the cocoadocs installation instructions (here) for installing Alamofire and it still is not working. I made sure everything has the same deployment target.
Embedded Binaries and Frameworks

Here's my podfile text.

source 'https://github.com/CocoaPods/Specs.git'
platform :ios, ‘9.2’
use_frameworks!

target 'MyApp' do
    pod 'Alamofire', '~> 3.0'
end

target 'MyAppTests' do

end

target 'MyAppUITests' do

end

Also, I tried "$ pod install" again in Terminal and got this message:

[!] The `App [Debug]` target overrides the `EMBEDDED_CONTENT_CONTAINS_SWIFT` build setting defined in `Pods/Target Support Files/Pods-App/Pods-App.debug.xcconfig'. This can lead to problems with the CocoaPods installation
    - Use the `$(inherited)` flag, or
    - Remove the build settings from the target.

After following Sohil's suggestions, XCode now recognizes the Alamofire module, but 22 new issues have arisen.

Update #2: So I'm now on Xcode 7.3 and Swift 2.2, but I'm receiving a new error with the workspace Link: "ld: framework not found Alamofire. clang: error: linker command failed with exit code 1 (use -v to see invocation)."

回答1:

Do the following things and you can import any swift file from "Pods"

1) Clean your project

2) Make sure that all your "Pods" > "Build Settings" > "Build Active Architecture Only" is set to "NO".

3) Don't run, just build your project.

4) Now, import any file from "Pods" to any swift file

E.g.: import Alamofire

5) Again, build project and it will work as expected. Finally, you can access it properties

Update:

For the updated question, I hope you are using Xcode 7.3 so please update the Alamofire to Swift 2.2

Hope this helps!

回答2:

Please check this screenshot and compare to your build setting may this is helpful to you

回答3:

For me the solution was to open the "App".xcworkspace as pointed by the cocoapods documentation

The steps was:

Close project
Close xcode
Go to terminal
type "open |App|.xcworkspace"

When I opened Xcode it was still pointing the error then I built the project (cmd+b) and everything is fine now.

回答4:

The target overrides the OTHER_LDFLAGS build setting.

Use the $(inherited) flag in TARGENTS -> Build Settings -> Framework Search Paths

回答5:

in my case, i couldn't run archive after change bundle name. I've cleaned build folder and run pod install then everything worked fine.

来源：https://stackoverflow.com/questions/36417151/no-such-module-alamofire-xcode-wont-recognize-alamofire-framework

标签

ios

xcode

swift

cocoapods

alamofire